New solar cell technology gives light waves 'amnesia'

September 27, 2011 By Jared Sagoff
A specialized piece of glass called a luminescent solar concentrator can intensify incoming light. The green and orange rings are produced by its fluorescence.

( -- For years, scientists have dealt with the problem of trying to increase the efficiency and drive down the cost of solar cells. Now researchers have hit upon a new idea—trying to give the light collected by solar cells a bit of 'amnesia.'

At the U.S. Department of Energy's (DOE) Argonne National Laboratory, nanoscientists Chris Giebink and Gary Wiederrecht, collaborating with Northwestern University Professor Michael Wasielewski, have investigated the use of fluorescent plastics called luminescent solar concentrators (LSCs) that can be used to lower the cost of electricity from .

“In order to make solar power competitive in energy markets, we either need to get more energy from the cells we've already developed or find ways to make cheaper cells that give us the same amount of energy,” Giebink said.

The three researchers are part of the Argonne-Northwestern Solar Energy Research Center, one of 46 Energy Frontier Research Centers established in 2009 and supported by DOE's Office of Science.

Concentrating sunlight is one strategy to squeeze more power out of existing solar cells, which ultimately reduces the cost of the energy they produce. The question occupying researchers today is how best to gather as much sunlight as cheaply as possible. Although lenses and mirrors are one solution—think burning a piece of paper with a magnifying glass on a sunny day—they must be continually aimed at the sun as it moves across the sky each day, which requires an expensive tracking system.

Luminescent solar concentrators are an inexpensive, alternative approach that do not require solar tracking because they capture sunlight and change it to a different wavelength, according to Giebink. “We're actively shifting the frequency of the light by absorbing and re-emitting it,” he said. “LSCs act kind of like flat funnels—we try to absorb a lot of light over the face of a plastic slab filled with dye, and then re-direct it all back out the edges. The whole process is designed to intensify the light as much as possible.”

The theoretical potential for this intensification, Giebink said, can exceed the equivalent of one hundred “suns”—the measurement of solar radiation on one spot. However, actual implementation has until now failed to produce such high intensities. “The main problem we're running into is that light is getting lost in the slabs either due to reabsorption or to scattering, and that's the problem we have to solve,” he said.

Using instrumentation and equipment at Argonne's Center for Nanoscale Materials, the researchers focused on altering the way light is re-emitted and reabsorbed inside an LSC by taking advantage of optical ‘microcavity' effects, which occur when the dimensions of a structure are similar to the wavelength of light. In this case, the scientists were able to use a series of thin films with nanometer-scale changes in thickness to produce a ‘resonance-shifting' effect, in which light fails to “recognize” the environment that it is emitted from, drastically reducing reabsorption. “It really is like giving light amnesia—if forgets how it came in, it's less likely to get reabsorbed or scattered out,” Wiederrecht said.

Although the Argonne experimental research explored how LSCs work only in one dimension, both Giebink and Wiederrecht believe that a two-dimensional LSC analysis would show even greater efficacy for resonance-shifting. “By finding better and better ways to pull this kind of switcheroo, the higher the we're going to get,” Giebink said. “We've demonstrated the general principle, now we just have to find the best pattern of dye thicknesses or alternatively the best way to vary the thickness of the glass.”

Explore further: Solar cells can be made thinner and lighter with the help of aluminum particles

More information: N.C. Giebink, G.P. Wiederrecht, and M.R. Wasielewski, "Resonance-shifting to circumvent reabsorption loss in luminescent solar concentrators," Nat. Photon. (Sept. 25, 2011). doi:10.1038/nphoton.2011.236 (online)

Related Stories

Device can heat home, save money

April 19, 2011

( -- A new polymer-based solar-thermal device is the first to generate power from both heat and visible sunlight – an advance that could shave the cost of heating a home by as much as 40 percent.

Nano-tuned solar cells

May 18, 2011

Solar cells that are more effective and cost less in production: Within the EU-project N2P (Nano to Product) researchers developed nano tuned surfaces to gain both.

An upside-down cake throws a new light on photovoltaics

September 9, 2011

Do better with less. That is the challenge the researchers of the Swiss Federal Institute of Technology in Lausanne (EPFL) have set for themselves, supported by the Swiss National Science Foundation and the Federal Office ...

Recommended for you

Scientists manipulate surfaces to make them invisible

October 21, 2016

Most lenses, objectives, eyeglass lenses, and lasers come with an anti-reflective coating. Unfortunately, this coating works optimally only within a narrow wavelength range. Scientists at the Max Planck Institute for Intelligent ...


Adjust slider to filter visible comments by rank

Display comments: newest first

not rated yet Sep 27, 2011
nice. Instead of trying to generate energy from the whole spectrum, you convert the spectrum to the part of it that you want to generate energy from.

adding a plastic with multiple coatings will definitely drive up the costs of the solar panels, however, if the efficiency gain is enough, it can overcome that obstacle.

So I look forward to more, hopefully they make some good progress on this.
not rated yet Sep 27, 2011
The main advantage is, you can use window glass as a light concentrator for solar cells - the light will be collected at is sides.
not rated yet Sep 27, 2011
The only problem I see with this is that these materials used to convert the wavelengths of light will have an efficiency all their own. I mean, how far will you be able to tune this efficiency such that it yields enough photons exiting towards your target area to actually be worth using? Eliminating scattering effects is no simple task as this article hand waves over like it is...
5 / 5 (1) Sep 28, 2011
I wonder if the plastic will be cheap enough for it to be replaced before it fades and loses its efficiency.

Please sign in to add a comment. Registration is free, and takes less than a minute. Read more

Click here to reset your password.
Sign in to get notified via email when new comments are made.