Optical fiber transmission quality can now be tested without the need to take measurements at both ends

Aug 19, 2011

Light traveling in an optical fiber loses power over distance. A number of factors are responsible for this power loss, but one that is particularly important at high data rates is the loss that occurs due to changes in light polarization. Hui Dong at the A*STAR Institute for Infocomm Research and co-workers1 have developed and tested a method of determining this polarization-dependent loss (PDL) in an optical fiber cable by taking measurements from just one end of the fiber. The new technique avoids the difficulty of having to arrange and coordinate access to both ends of a fiber optic cable, which may be tens of kilometers apart.

In , PDL predominantly occurs not in the fiber itself but in the couplers and filters used to regulate light in the fiber, and can have a significant impact on signal quality and network performance. Until now the measurement of PDL in cables has required an optical source attached to one end transmitting to a receiver at the other. A technique requiring access to only one end, however, was proposed theoretically by Italian researchers, but had yet to be verified experimentally.

The proposed technique requires the to be birefringent at the end at which are to be taken— that is, the must include imperfections that interact in different ways with the two perpendicular components of light polarization. This polarization-dependent interaction causes the two polarization modes to travel at different speeds, splitting the light beam into two.

The technique then proposes estimating the PDL from the maximum loss encountered in a round-trip along the cable. This can be achieved by measuring light backscatter as photons of light emitted in four different polarization states bounce back from interacting with the molecular structure of the cable. Over a distance of ten kilometers, measurements taken with an experimental setup built by the researchers showed good agreement with measurement made using standard techniques with a source and receiver at either end.

“We want to continue the experimental work on our PDL measurement in fiber links,” says Dong. “The PDL in a fiber link is a function of fiber length. Using our new technique, we should be able to measure the relationship between PDL and fiber length.” As PDL varies with environmental conditions such as temperature or stress on the cable, the new technique could also be used to sense these changes by detecting PDL variations.

Explore further: 'Smart' bandage emits phosphorescent glow for healing below

More information: Dong, H., Shum, P., Gong, Y. & Sun, Q. Single-ended measurement of polarization-dependent loss in an optical fiber link. IEEE Photonics Technology Letters 23, 185–187 (2011).

Provided by Agency for Science, Technology and Research (A*STAR)

5 /5 (1 vote)
add to favorites email to friend print save as pdf

Related Stories

Chaotic laser brings out higher precision OTDR

Jun 03, 2010

Professor Wang Yun Cai and his student Wang An Bang reported a new concept of optical time domain reflectometry (OTDR) based on a chaotic light correlation method. This will be useful for precise fault location in fiber links ...

Physicists demonstrate a time cloaking device

Jul 18, 2011

Physicists Moti Fridman and colleagues at Cornell University have successfully demonstrated a so-called time cloaking device that is able to “hide” time for 15 trillionths of a second. In a paper published on arXiv, the re ...

Recommended for you

Researchers develop powerful, silicon-based laser

Sep 29, 2014

A silicon-based laser that lases up to a record 111°C, with a threshold current density of 200 A/cm2 and an output power exceeding 100 mW at room temperature, has been demonstrated by collaborating researcher ...

Predicting landslides with light

Sep 29, 2014

Optical fiber sensors are used around the world to monitor the condition of difficult-to-access segments of infrastructure—such as the underbellies of bridges, the exterior walls of tunnels, the feet of dams, long pipelines ...

Studies in laser physics help understand rogue waves

Sep 29, 2014

(Phys.org) —University of Auckland physicist Dr Miro Erkintalo is part of an international team investigating how lasers and optical fibres can be used to understand freakishly large waves on the ocean.

User comments : 0