Detecting cancer with the prick of a finger (w/ Video)

November 16, 2010
Chemistry professor Adam Woolley created a microchip that could speed up cancer detection.

(PhysOrg.com) -- Researchers at BYU have created a micro device that could both decrease the amount of blood and time needed to test for cancer-markers in a patient’s blood.

Chemistry professor Adam Woolley's research, published in a recent issue of the journal, , details the device and technique that would allow for effective detection of biomarkers in a sample in a matter of minutes rather than days or weeks.

“You could walk into the doctor’s office, the nurse could prick your finger instead of sticking a needle in your vein, and 30 or 40 minutes later, you’d get the results back in the same doctor’s office,” Woolley said.

The video will load shortly

Woolley said the current approach for detecting biomarkers, ELISA (enzyme-linked immunosorbent assay), works well as long as you’re doing it in high volumes. This is why blood samples are usually sent to a clinical lab where they can run dozens of samples at the same time.

And while ELISA is efficient and cost effective if, say, there are 90 blood samples to process, the BYU micro device would allow a technician to look at just one sample quickly and cost-effectively to determine if there are markers for, say, breast cancer or prostate cancer.

The microchip researched and created by Woolley and doctoral student Weichun Yang could lead to effective testing for cancer-marking proteins with the use of only microliters of blood instead of milliliters – a smaller sample by a factor of a thousand.

“Detecting cancer biomarkers in a point-of-care setting can significantly improve the throughput of cancer screening and diagnose a cancer tumor at its early stage,” said Yang, lead author on the paper. “These devices provide a robust, quick, and portable system for early stage disease diagnosis.”

Whereas ELISA uses a series of antibodies as hooks to grab targeted proteins and identify them, Woolley’s method uses only one antibody step, which is then followed by a step where voltage is applied and the proteins are identified by the speed at which they move.

The new micro device can also detect multiple biomarkers in blood simultaneously. In this particular round of research, Woolley and his team used the chip to detect four biomarkers simultaneously, but the device has the potential to detect upwards of 10 or 20.

Woolley said he and his team are now looking at ways to speed up the biomarker detection process even more. Ideally, he’d like to get the 30- to 40-minute process down to 20, 15 or even 10 minutes.

“If you learn from your doctor that you might have a life-threatening disease and that some initial testing must be performed, you don’t want to wait weeks to find out what’s going on,” Woolley said. “You’d like to know that very day.”

Woolley’s research was funded by a National Institutes of Health grant awarded in 2006. Other co-authors on the study were post-doctorates Ming Yu and Xiuhua Sun.

Explore further: Columbia engineer designs handheld device used to diagnose illness

Related Stories

Looking for new source of cancer markers in blood

October 27, 2010

The future of cancer diagnosis may lie in just a few milliliters of blood, according to a research team led by Professor Arie Admon of the Technion-Israel Institute of Technology.

Modern society made up of all types

November 4, 2010

Modern society has an intense interest in classifying people into ‘types’, according to a University of Melbourne Cultural Historian, leading to potentially catastrophic life-changing outcomes for those typed – ...

Recommended for you

Force triggers gene expression by stretching chromatin

August 26, 2016

How genes in our DNA are expressed into traits within a cell is a complicated mystery with many players, the main suspects being chemical. However, a new study by University of Illinois researchers and collaborators in China ...

3-D printed structures that 'remember' their shapes

August 26, 2016

Engineers from MIT and Singapore University of Technology and Design (SUTD) are using light to print three-dimensional structures that "remember" their original shapes. Even after being stretched, twisted, and bent at extreme ...

New method developed for producing some metals

August 25, 2016

The MIT researchers were trying to develop a new battery, but it didn't work out that way. Instead, thanks to an unexpected finding in their lab tests, what they discovered was a whole new way of producing the metal antimony—and ...

New electrical energy storage material shows its power

August 24, 2016

A powerful new material developed by Northwestern University chemist William Dichtel and his research team could one day speed up the charging process of electric cars and help increase their driving range.

0 comments

Please sign in to add a comment. Registration is free, and takes less than a minute. Read more

Click here to reset your password.
Sign in to get notified via email when new comments are made.