Finding a buckyball in photovoltaic cell

September 28, 2010

Polymer-based photovoltaic cells have some real advantages compared to the currently used semiconductor-based cells. They are easy to make and the materials are cheap. The challenge is to figure out how to make efficient cells while keeping the manufacturing cost low.

One approach uses a light-absorbing polymer along with a derivative of a sixty-carbon fullerene molecule, commonly known as a buckyball. For maximum efficiency, the two materials must be present in thin layers near opposite electrodes but most analytical methods cannot distinguish between polymer and the buckyball well enough to characterize the plastic solar cell film.

New research reported in the describes a technique that analyzes the reflection of to locate the buckyballs within the .

"Neutron scattering is not a new technique but it has yet to be widely applied to this class of materials," says researcher Brian Kirby of the National Institute of Standards and Technology. "With this paper, we are providing an instruction book for researchers who want to use neutrons to study polymer photovoltaics."

He points out that while neutron scattering requires a reactor or - not typical lab equipment - scattering facilities are widely available to industrial and academic users.

Because both the polymer and the buckyball are composed mostly of carbon and their locations must be defined within a few nanometers, standard techniques have not provided sufficient resolution to describe the location of the buckyballs. As a result, much of the research on organic has been a trial and error process. Neutrons happen to interact with the and the buckyball derivative very differently, leading to a sharp contrast.

"Our goal is more effective research on photovoltaic devices," says researcher Jon Kiel of the University of Delaware. "Using this technique, we have confirmed that particles are not distributed in the ideal way and have shown how to evaluate the distribution in new materials."

Explore further: SSRL Aids Development of Plastic Electronics

More information: The article, "Phase-sensitive neutron reflectometry measurements applied in the study of photovoltaic films" by J. W. Kiel, M. E. Mackay, B. J. Kirby, B. B. Maranville and C. F. Majkrzak is published in The Journal of Chemical Physics.

Related Stories

SSRL Aids Development of Plastic Electronics

May 4, 2006

For close to a decade, researchers have been trying to improve the performance of plastic semiconductors to the level of amorphous silicon—the semiconductor used in low-cost electronics such as photovoltaic cells for solar ...

Silver Nanoparticles Give Polymer Solar Cells A Boost

October 5, 2009

( -- Small bits of metal may play a new role in solar power. Researchers at Ohio State University are experimenting with polymer semiconductors that absorb the sun’s energy and generate electricity. The goal: ...

Recommended for you

A new form of real gold, almost as light as air

November 25, 2015

Researchers at ETH Zurich have created a new type of foam made of real gold. It is the lightest form ever produced of the precious metal: a thousand times lighter than its conventional form and yet it is nearly impossible ...

Moonlighting molecules: Finding new uses for old enzymes

November 27, 2015

A collaboration between the University of Cambridge and MedImmune, the global biologics research and development arm of AstraZeneca, has led researchers to identify a potentially significant new application for a well-known ...

Atom-sized craters make a catalyst much more active

November 24, 2015

Bombarding and stretching an important industrial catalyst opens up tiny holes on its surface where atoms can attach and react, greatly increasing its activity as a promoter of chemical reactions, according to a study by ...


Please sign in to add a comment. Registration is free, and takes less than a minute. Read more

Click here to reset your password.
Sign in to get notified via email when new comments are made.