Plastic as a conductor

Dec 02, 2008
A plastic-metal hybrid as a granulate or a strand. In the next step the conductive material can be plasticized (softened) again and applied as a printed circuit board. © Fraunhofer IFAM

(PhysOrg.com) -- Plastic that conducts electricity and metal that weighs no more than a feather? It sounds like an upside-down world. Yet researchers have succeeded in making plastics conductive and cutting production costs at the same time.

You could hardly find greater contrasts in one and the same team. Plastic is light and inexpensive, but insulates electric current. Metal is resilient and conducts electricity, but it is also expensive and heavy. Up to now, it has not been possible to combine the properties of these two materials.

The IFAM in Bremen (Germany) has devised a solution that combines the best of both worlds without requiring new machinery to process the components. The greatest challenge for the researchers was getting the plastic to conduct electricity, for plastic-metal hybrids are to be used in the very places where plastic components are equipped with printed circuit boards, for instance in cars or aircraft. Until now, this was only possible via the roundabout route of punching and bending metal sheets in an elaborate process in order to integrate them in a component.

The new solution is simpler: a composite material. The different materials are not merely slotted together or bonded, but mixed in a special process to form a single material. This process produces a homogeneous and fine-meshed electrically conductive network. The composite possesses the desired chemical stability and low weight, coupled with the electrical and thermal conductivity of metals. As it will no longer be necessary in future to integrate metal circuit boards and the components will soon be able to be produced in a single work step, the production costs and the weight of the material are drastically reduced.

Automobile and aircraft manufacturers, in particular, will benefit from this development. The headlamp housings on a car, for example, are made of plastic. Until now, punched metal sheets have been installed in order to illuminate the headlamps. If the housings were fitted with circuit boards made of the conductive plastic-metal hybrids, they could be produced more efficiently and at lower cost than ever before. Many components of an aircraft, such as the fuselage, are partly made of carbon fiber composites (CFC). However, they lack the ability to conduct electricity. A stroke of lightning would have fatal consequences. A plastic-metal hybrid would be a good alternative for discharge structures on components.

Provided by Fraunhofer-Gesellschaft

Explore further: ONR tests new glasses for augmented reality system with Marines

Related Stories

Duke to provide water to NC residents with tainted wells

May 13, 2015

Duke Energy says it will begin delivering bottled water to homeowners living near its coal ash pits in North Carolina, even as the nation's largest electricity company denies responsibility for its neighbors' ...

Generating eco-friendly power with metal rotor blades

May 07, 2015

Wind turbines deliver environmentally friendly electricity. Yet the fiber-reinforced plastics often used in very large rotor blades are almost impossible to recycle. Not so with steel blades: since these ...

Novel catalyst used to make styrene in one step

May 05, 2015

(Phys.org)—Styrene is an important industrial chemical. It is the precursor to polystyrene which is used in various every day plastic products, like disposable cups, packaging, and insulation. Over 18.5m ...

Recommended for you

User comments : 0

Please sign in to add a comment. Registration is free, and takes less than a minute. Read more

Click here to reset your password.
Sign in to get notified via email when new comments are made.