Researchers create polymer solar cells with higher efficiency levels

November 26, 2008

Currently, solar cells are difficult to handle, expensive to purchase and complicated to install. The hope is that consumers will one day be able to buy solar cells from their local hardware store and simply hang them like posters on a wall.

A new study by researchers at the UCLA Henry Samueli School of Engineering and Applied Science has shown that the dream is one step closer to reality. Reporting in the Nov. 26 edition of the Journal of the American Chemical Society, Yang Yang, a professor of materials science and engineering, and colleagues describe the design and synthesis of a new polymer, or plastic, for use in solar cells that has significantly greater sunlight absorption and conversion capabilities than previous polymers.

The research team found that substituting a silicon atom for carbon atom in the backbone of the polymer markedly improved the material's photovoltaic properties. This silole-containing polymer can also be crystalline, giving it great potential as an ingredient for high-efficiency solar cells.

"With the reality of today's energy crisis, a new-game changing technology is required to make solar cells more popular," Yang said. "We hope that our newly synthesized polymer can eventually be used on solar cells far beyond their current rooftop applications. Imagine a house or car covered and powered by flexible solar films. Our dream is to see solar cells used everywhere."

Polymers are lightweight, low-cost plastics used in packaging materials and inexpensive products like insulators, pipes, household products and toys. Polymer solar cells utilize organic compounds to produce electricity from sunlight. They are much cheaper to produce than traditional silicon-based solar cells and are also environmentally friendly.

But while polymer solar cells have been around for several years, their efficiency has, until recently, been low. The new polymer created by Yang's team reached 5.1 percent efficiency in the published study but has in a few months improved to 5.6 percent in the lab. Yang and his team have proven that the photovoltaic material they use on their solar cells is one of the most efficient based on a single-layer, low-band-gap polymer.
At a lower band gap, the polymer solar cell can better utilize the solar spectrum, thereby absorbing more sunlight. At a higher band gap, light is not easily absorbed and can be wasted.

"Previously, the synthesizing process for the polymer was very complicated. We've been able to simplify the process and make it much easier to mass produce," said Jianhui Hou, UCLA postdoctoral researcher and co-author of the study. "Though this is a milestone achievement, we will continue to work on improving the materials. Ideally we'd like to push the performance of the solar cell to higher than 10 percent efficiency. We know the potential is there."

"We hope that solar cells will one day be as thin as paper and can be attached to the surface of your choice," added co-author Hsiang-Yu Chen, a UCLA graduate student in engineering. "We'll also be able to create different colors to match different applications."

Source: University of California - Los Angeles

Explore further: Hybrid solar cell converts both light and heat from sun's rays into electricity

Related Stories

Tuning polymer interpenetration

September 17, 2015

Polymer nanocomposites are used in a wide range of applications, from automobile parts and tires to high-tech electronics and solar cells.

Team creates functional ultrathin solar cells

August 27, 2015

(—A team of researchers with Johannes Kepler University Linz in Austria has developed an ultrathin solar cell for use in lightweight and flexible applications. In their paper published in the journal Nature Materials, ...

Microscopic rake doubles efficiency of low-cost solar cells

August 13, 2015

Researchers from the Department of Energy's SLAC National Accelerator Laboratory and Stanford University have developed a manufacturing technique that could double the electricity output of inexpensive solar cells by using ...

Recommended for you

The hand and foot of Homo naledi

October 6, 2015

The second set of papers related to the remarkable discovery of Homo naledi, a new species of human relative, have been published in scientific journal, Nature Communications, on Tuesday, 6 October 2015.

New surfaces delay ice formation

October 6, 2015

If you've ever waited on an airport runway for your plane to be de-iced, had to remove all your food so the freezer could defrost, or arrived late to work because you had to scrape the sheet of ice off your car windshield, ...


Please sign in to add a comment. Registration is free, and takes less than a minute. Read more

Click here to reset your password.
Sign in to get notified via email when new comments are made.