Knee brace generates electricity from walking

Feb 07, 2008
Knee brace generates electricity from walking
The biomechanical energy harvester includes an aluminum chassis and generator mounted on a customized orthopaedic knee brace. The device weighs 3.5 lbs. Credit: Greg Ehlers/Simon Fraser University

A new energy-capturing knee brace can generate enough electricity from walking to operate a portable GPS locator, a cell phone, a motorized prosthetic joint or an implanted neurotransmitter, research involving the University of Michigan shows.

A report on the device is published in the Feb. 8 issue of the journal Science. Authors include researchers from Simon Fraser University in Canada and the University of Pittsburgh, in addition to U-M.

The wearable mechanism works much like regenerative braking charges a battery in some hybrid vehicles, said Arthur Kuo, an associate professor of mechanical engineering at U-M and an author of the paper.

Regenerative brakes collect the kinetic energy that would otherwise be dissipated as heat when a car slows down. This knee brace harvests the energy lost when a human brakes the knee after swinging the leg forward to take a step.

Kuo, who called the device "a cocktail-napkin idea," says knee joints are uniquely suited for this endeavor.

"There is power to be harvested from various places in the body, and you can use that to generate electricity. The knee is probably the best place," he said. "During walking, you dissipate energy in various places, when your foot hits the ground, for example. You have to make up for this by performing work with your muscles.

"The body is clever," Kuo said. "In a lot of places where it could be dissipating energy, it may actually be storing it and getting it back elastically. Your tendons act like springs. In many places, we're not sure whether the energy is really being dissipated or you're just storing it temporarily. We believe that when you're slowing down the knee at the end of swinging the leg, most of that energy normally is just wasted."

The scientists tested the knee brace on six men walking leisurely on a treadmill at 1.5 meters per second, or 2.2 miles per hour. They measured the subjects' respiration to determine how hard they were working. A control group wore the brace with the generator disengaged to measure how the weight of the 3.5-pound brace affected the wearer.

In the mode in which the brace is only activated while the knee is braking, the subjects required less than one watt of extra metabolic power for each watt of electricity they generated. A typical hand-crank generator, for comparison, takes an average of 6.4 watts of metabolic power to generate one watt of electricity because of inefficiencies of muscles and generators.

"We've demonstrated proof of concept," Kuo said. "The prototype device is bulky and heavy, and it does affect the wearer just to carry. But the energy generation part itself has very little effect on the wearer, whether it is turned on or not. We hope to improve the device so that it is easier to carry, and to retain the energy-harvesting capabilities."

A lighter version would be helpful to hikers or soldiers who don't have easy access to electricity. And the scientists say similar mechanisms could be built into prosthetic knees other implantable devices such as pacemakers or neurotransmitters that today require a battery, and periodic surgery to replace that battery.

"A future energy harvester might be implanted along with such a device and generate its own power from walking," Kuo said.

Source: University of Michigan

Explore further: New research to realise the sensor 'pipe dream'

Related Stories

Recommended for you

Footage from drone perspective with CyPhy Works

2 hours ago

Sometimes you hear enthusiasts talking about high-quality footage. Now the chatter can shift over to discussions about quality drone footage. The good news is that a talented team has come up with a conc ...

Engineering students create real-time 3-D radar system

15 hours ago

Spencer Kent stands nervously in front of Team D.R.A.D.I.S.' booth at Rice University's annual Engineering Design Showcase. Judging begins in about 10 minutes, and his teammate Galen Schmidt is frantically ...

New research to realise the sensor 'pipe dream'

22 hours ago

Three new research projects funded by Australia's energy pipeline industry have been initiated at Deakin University. The projects aim to develop a world-first pipeline health monitoring system that will be ...

Economical and effective security design

May 04, 2015

Operators of infrastructures such as power grids and airports are expected to ensure a high level of security – but their financial means are limited. Fraunhofer researchers have developed an analysis tool ...

Ten-engine electric plane prototype takes off

May 04, 2015

A team at NASA's Langley Research Center is developing a concept of a battery-powered plane that has 10 engines and can take off like a helicopter and fly efficiently like an aircraft. The prototype, called ...

User comments : 2

Adjust slider to filter visible comments by rank

Display comments: newest first

SDMike
not rated yet Feb 08, 2008
How about heel strike energy harvesting? Generate power and protect the wearer.
zevkirsh
not rated yet Feb 08, 2008
this was in the front page section of the new york times, !

Please sign in to add a comment. Registration is free, and takes less than a minute. Read more

Click here to reset your password.
Sign in to get notified via email when new comments are made.