Physicist demonstrates how light can be used to remotely operate micromachines

June 18, 2007

A research team led by Umar Mohideen, a physicist at the University of California, Riverside, has demonstrated in the laboratory that the Casimir force – the small attractive force that acts between two close parallel uncharged conducting plates – can be changed using a beam of light, making the remote operation of micromachines a possibility.

The Casimir force results when the properties of “virtual photons” are modified. While a photon is the carrier particle of electromagnetic interactions, a virtual photon is a particle that exists for so brief an instant as an intermediary in a process that it can never be directly observed.

Because virtual photons are ever-present in empty space, studying the Casimir force allows physicists to learn the properties of the quantum nature of space.

In their study, Mohideen and his colleagues used a ball and a flat plate to simulate two parallel plates. “Where the ball and plate are close to each other, the surfaces are considered to be almost parallel at microscopic distances,” said Mohideen, a professor of physics in the Department of Physics and Astronomy.

In each of his experiments, the ball (diameter 200 microns) was made of gold, a chemically clean metal that does not tarnish; only the material that made up the flat plate varied from experiment to experiment.

In one such experiment, the researchers used a plate of silicon, a material commonly used in the semiconductor industry, and measured the “carrier density” or the number of electrons in the plate.

They then compared the Casimir force that arose each time between the gold ball and a series of silicon plates of different carrier densities. They found that the Casimir force was measurably different between the ball and any two silicon plates only when the carrier density of one plate was at least 10,000 times larger than the carrier density of the second plate.

“We then asked ourselves if it was possible to bring about this density difference in other ways,” Mohideen said.

The researchers next experimented with the gold ball and a silicon plate with identical carrier densities. Training a beam of light on the plate, they were able to change the plate’s carrier density by an amount that was enough to change the Casimir force between the plate and the ball.

When light is absorbed by silicon, photons are converted into positive and negative charges, Mohideen explained. It is the increase in the number of electrons (negative charges) that increases the Casimir force.

“Using this result, it should be possible now to make special probes that can check for changes in electron density,” he added. “It can be used, too, to make new micromachines that can be remotely operated simply by using light.”

Micromachines find applications in complex systems of tiny gears and levers. They are used to reroute light between optical fibers in optical communication. They also are used in accelerometers that can trigger an airbag in an accident.

“Because of the sensitivity associated with light, we can match theory with experiment with much more precision at a very small scale,” Mohideen said. “This would help physicists better understand how a theory called the Lifshitz theory should be applied in experiments on the Casimir force.”

The Lifshitz theory predicts that the strength of the Casimir force between two surfaces is dependent on the distance between the surfaces (the smaller the distance, the greater the force). The theory also predicts how the number of electrons in the surface changes the force, and gives an explanation of how virtual photons interact with electrons.

Next in their research, the physicists plan to improve the sensitivity of their experiments using more precise detection techniques. They will attempt, too, to understand exactly how electrons and virtual photons interact.

Source: University of California - Riverside

Explore further: A first step towards testing dark energy theories on the table top

Related Stories

Revisiting quantum effects in MEMS

November 15, 2013

New calculations shows that the influence of quantum effects on the operating conditions of nanodevices has, until now, been overestimated.

Recent study reduces Casimir force to lowest recorded level

October 1, 2013

( —A research team that includes a physics professor at Indiana University-Purdue University Indianapolis (IUPUI) has recorded a drastically reduced measurement of the Casimir effect, a fundamental quantum phenomenon ...

Recommended for you

Fusion reactors 'economically viable' say experts

October 2, 2015

Fusion reactors could become an economically viable means of generating electricity within a few decades, and policy makers should start planning to build them as a replacement for conventional nuclear power stations, according ...

Iron-gallium alloy shows promise as a power-generation device

September 29, 2015

An alloy first made nearly two decades ago by the U. S. Navy could provide an efficient new way to produce electricity. The material, dubbed Galfenol, consists of iron doped with the metal gallium. In new experiments, researchers ...

Invisibility cloak might enhance efficiency of solar cells

September 30, 2015

Success of the energy turnaround will depend decisively on the extended use of renewable energy sources. However, their efficiency partly is much smaller than that of conventional energy sources. The efficiency of commercially ...

Extending a battery's lifetime with heat

October 1, 2015

Don't go sticking your electronic devices in a toaster oven just yet, but for a longer-lasting battery, you might someday heat them up when not in use. Over time, the electrodes inside a rechargeable battery cell can grow ...


Please sign in to add a comment. Registration is free, and takes less than a minute. Read more

Click here to reset your password.
Sign in to get notified via email when new comments are made.